Once completed, carefully remove sharpened knife from the sharpening slot with the lever in the bottom position to prevent dulling of the blade edge. Keep hands away from knife edge while removing knife from sharpening slot. Insert the knife into the designated sharpening slot until the blade comes to a hard stop. Knives with large handles (Chef and Slicing Knives) should be inserted into upper sharpening slot. Knives with small handles (Utility and Paring) should be inserted into lower sharpening slot.

As you hold the lever in the down position with your left hand, pull the wheel holder down and towards you with your right hand. The wheel holder should connect with the snap feature to be held in place. NOTE: The wheel holder may be greasy and/or oily. Records the default button state of the corresponding category & the status of CCPA. It works only in coordination with the primary cookie. Replace the wheel by placing the new wheel in the wheel holder. It can be installed in either direction. Insert the wheel pin through the wheel and snap the wheel pin clip in place.Verify the wheel is installed correctly by spinning the wheel. The wheel should rotate in the wheel holder. If it is jammed, is wobbly or easily pops out, repeat until it rolls freely. NOTE: The wheel is meant to be angled in the wheel holder. Remove the wheel by unsnapping and rotating the wheel pin clip upwards 90 degrees. Slide the wheel pin out and remove the wheel. Discard the wheel, but reserve the wheel pin.